Tie Down Dock System Components & Jet Rail on Tie Down Engineering

Trailer Component Locator Marine Aftermarket Trailer Accessories OEM Trailer Manufactured Housing Roofing Products Cables & Hardware Industrial Laser Cutting Services
& Tube Fabrication Services Download Online Catalogs

Registered Users – Sign In


All Categories > Marine Aftermarket Trailer Accessories > Tie Down Dock System Components & Jet Rail


	Tie Down Dock System Components & Jet Rail
	Click on a category to drill down.


		Lag Bolt Set (3) Bolt and flat washer hot dip galvanized used to attach floatation drums to dock system.




		Carriage Bolt Set (3) Used to attach most component parts. Bolt, flat washer and nut hot dip galvanized. Match Carriage Bolt Sets with similar graded hardware.




		Hex Head Bolt Set Includes lock nut. Used to connect male and female T connectors. Galvanized Standard Grade




		Connector Pin Set For quick disconnect. Used to connect male and female T connectors. Galvanized 3/4" connector pin and hitch clip pin.




		Corners




		Back Up Plate 5" x 5" reinforcing plates are used to back up the Single T Males & Females, Outside Corners, Chain Retainers, Rolling Ramp Brackets & Corner Pipe Holders




		Washer Plates (2) Use two washer plates with each angle. Measures 1-1/2" L x 5" H.




		Angle Brackets/Clips (11) Use this heavy-duty angles for all cross supports.




		Backing Plates (2) For use with Piling Hoops. Standard Grade




		Inside Corner Pipe Holders (4) These heavy-duty inside corners should be used with one of the Outside Corners or Back Up Plates. Measures 8-1/2" L x 5" H. Requires carriage bolt set for attaching




		Outside Pipe Holders (2) OD bolts to outside of dock. Carriage bolt set required for attaching. Use 2" pipe to hold dock in place.




		Chain Retainers (2) Bolts to side of dock. Use weights and chains to hold dock in place. The use of Back Up Plates or Washer Plates is recommended. Accommodates 1/4", 3/8", & 1/2" chain. Measures 5" L x 5" H.




		Roller Assembly Heavy Duty Roller Assembly Bracket and roller bolt directly to the Deck Plate (Model 26416) and can be added to aid up-and-down motion of the dock in areas with tidal action. The 6" roller turns on a 5/8" diameter shaft and the 3/8" bracket is hot-dipped galvanized.




		Piling Holders




		Inside Rolling Ramp Bracket 5" x 11" x 1/4" galvanized steel. The use of Back Up Plates or Washer Plates is recommended. Includes left and right ramp brackets.




		Jet Rail & Jet Rail XL Jet Ski Lifts (2) The Jet Rail & Jet Rail XL are all galvanized steel PWC lift designed for easy one person "launch and load". The small foot print under the ski allows easy walk around while the watercraft is stored on the dock or seawall. The brake Wench and mount adjusts to any size watercraft and slides inside the lift when not in use, saving even more precious dock space. Carpeted bunk boards and all hardware are included. All you add is your PWC! Jet Rail maximum weight is 650 lbs. (Including gas & oil) Jet Rail XL maximum weight is 950 lbs. (Including gas & oil) One person launch n' load Easy assembly Nothing else to buy Small "footprint" takes up less room on dock